skracus
Active Member
Hello!
I updated the GT22 tonight to 4.1 and the Axe-Fx III to 1.15 All went well without issue with default settings. Everything functioned as expected. (great job Ron!!!) Now I am in the process of customizing my IA button layout and have run into some trouble. Page 1 configures fine with whatever button config I choose however when I try and assign IA buttons on Page 2 the process works fine and completes in the editor but when the transfer completes to the hardware all changes revert back to the way Page 2 was before the edit. I've not come across this problem before and wonder if I missed something in the setup with the new FW. I had been on 3.XX prior to today. Axe-Fx III is the only device being controlled by the GT22.
Re did the set up, factory reset etc. Working fine now.