ZachSelindh
Well-Known Member
Hey all, I'm having a very strange bug with my PBC that I hope isn't memory related...
I control my Line6 HX One using buttons on Page 4. When I read/write the button settings from the Editor to the PBC, everything looks good in the Editor GUI. But when I power cycle my PBC, the Button group on Page 4 doesn't save which button was turned on. This has led to some embarrassing moments when I expect a patch to pull up a compressor and it stays on the fuzz I had previously selected.
Bizarrely, this only happens when I've programmed the Button state from the Editor. If I program the button state from the pedal itself, then read from the Editor, it works properly. But that's not ideal, obviously I want the Editor to always have the final word.
Any suggestions?
I've attached my settings file. To test this; check out the 2nd preset in the song, called "Edgy | Generic", located at Preset 731. You'll see that in the Editor, I'm trying to send the "Red Squeeze" preset from the button. But on my unit, when I write those settings, that button is off and doesn't send its messages. You also might need to power cycle the unit after writing the changes, which is part of why I'm worried it's a memory issue.
I control my Line6 HX One using buttons on Page 4. When I read/write the button settings from the Editor to the PBC, everything looks good in the Editor GUI. But when I power cycle my PBC, the Button group on Page 4 doesn't save which button was turned on. This has led to some embarrassing moments when I expect a patch to pull up a compressor and it stays on the fuzz I had previously selected.
Bizarrely, this only happens when I've programmed the Button state from the Editor. If I program the button state from the pedal itself, then read from the Editor, it works properly. But that's not ideal, obviously I want the Editor to always have the final word.
Any suggestions?
I've attached my settings file. To test this; check out the 2nd preset in the song, called "Edgy | Generic", located at Preset 731. You'll see that in the Editor, I'm trying to send the "Red Squeeze" preset from the button. But on my unit, when I write those settings, that button is off and doesn't send its messages. You also might need to power cycle the unit after writing the changes, which is part of why I'm worried it's a memory issue.