Recent content by Josh Demolar

The pedal would need to have TRS jacks with the capability to run each circuit independently. Many two-channel overdrives have this capability. I’d imagine that modding one to do so depends on the complexity of the circuit. Some of the JHS overdrive pedals have the red remote jack, which you...

It’s a learning curve for sure. That’s what this forum is for!

I haven't looked at your file, but the most frequent cause of this is having "Send on Preset Change" checked on at least one of your IA buttons on another page. You probably have this setting checked on one of your Page 5 buttons, which means that whatever commands you're sending on that button...

I'll admit at the start that I don't have firsthand experience with the 6X (I've used the 10 for several years). How does it handle stereo pedals that are reordered to be before a mono pedal? That's one unknown to me that could impact how you plan your board. The challenge is that you have...

@eaudio Thanks for posting this. These look slightly narrower than the SP400, do you know if they will fit well on a stereo Boss pedal like the DC-2W where the jacks are just close enough that the SP400s wouldn't fit side by side?

What inputs and outputs are you using on the H90? It sounds like a routing problem somewhere.

Things you can check: - Make sure the preset on the H90 has dry signal. I don’t know specifically how that pedal does it, but typically you can turn dry signal on/off, or kill dry on/off, or using the mix parameter. You want your dry signal (at least for this preset), so set it on or make sure...

What do you mean that your delay is inverted? Like you’re expecting a sound out of the left channel but hearing it on the right instead and vice versa? Or something else is happening?

All the buttons are programmable, so people like to customize the buttons in different ways. The PBC has plenty of buttons that can do almost anything you want, and you can have multiple button pages where the functions of each button changes as you bank through the pages, but having an extra...

So I haven't tested this out, but it looks like you can set time and note sync as separate parameters. Have you tried assigning each to its own CC #? For example, set Time to MIDI CC4, then set the min and max to 330ms. Then set Note Sync to MIDI CC5, and leave the full range (or whatever min...

Weird. After a closer read of the HX One instruction manual that you posted, it looks like maybe you have the inputs/outputs configured wrong based on the signal path you laid out in your original post. It looks like the send on the HX One is OUT R. Try switching the two outputs on the HX One...

Do you have midi daisy-chained, going from the PBC to one H9, then out of that H9 to the other H9 (possibly with other pedals in between)? If so, have you tried swapping the order of the H9’s (just for the midi path, not actual audio path)? I wonder if it’s more about a clear midi signal going...

For #1, it sounds like you’ll need a separate unit to split your signal. If you do it with a Y cable, you will weaken your signal and, as you’ve indicated, have a risk of phase issues. A good splitter should have buffered outputs to keep your signal strong, a phase inversion option, and a ground...

If you’re putting your amp models in the part of the Stomp’s signal path that’s in loop 8, then effects in loops 9 and 10 would have to come after the amps. Assuming that shifting everything a loop earlier (using loops 7-9 and putting the amp models in loop 10) is NOT an option, you might...

Yeah that does get confusing. To clear one thing up, midi doesn’t carry your guitar signal. It only carries the data to control your midi devices. As far as how to use the various effect loops, it does get complex with multiple loops. It’s also a bit trickier if you’re trading between a pedal...