So I have a monster rack in the studio with 2 x RG16s and I've just purchased a Y Not.
My MIDI chain is as follows:
Axess Electronics FX1 Midi Out >
RG16#1 Midi In > // RG16#1 Midi Thru >
RG16#2 Midi In // RG16#2 Midi Thru >
Y Not Midi In
I have RG16#1 on Midi Ch01, RG16#2 on Midi Ch02 and...
Quick question: is the Y-Not buffer located at the input or output?
Put another way, is there a buffer driving both outputs A and B? Or just on Output B to help drive the transformer.
Cheers
Sorry to resurrect an old thread but I have a question.
Why only use the Midi Thru jack? Doesn't the Midi Out port also send the same MIDI messages as received on the MIDI In port, or does this only occur on the MIDI Thru jack?
Cheers
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.