Recent content by Lars Bøgh

Not needed !

I figured it out by connecting the "send" signal from the amps to both tip and ring for the EG In9 connector. - I now achieve what I was looking for.

Hi Ron Now finished the wiring, but it don't work as expected. My setup is 2 combo amps, Mesa Boogie Mrk III and a Fender Hot Rod De ville, both equipped with an effect loop. I use a RJM Y-Not to switch between the preamp of the 2 combos. - My plan was to being able to switch between the preamp...

Thank you Ron. - Just needed to be sure about this, before staring up the wiring.

Hi Ron I have a question for the diagram in the Effect Gizmo manual page 19. To be specific the "send" cable, from both amps, going into EG In11. How should this cable be wired? - If you are using a standard insert cable, the one amps "send signal" will hit the tip of the TRS plug going into EG...

When you move the expression pedal, is there a reading of the value on the Timeline display? - If yes, you could store that value via Preset action, where you enter the cc value for the pedal (CC Toggle command).

I would love to have "Actions" added to the "Songs" tab in the editor. I have a 200+ songs programmed in the PBC, and of cause I use very similar presets in all those songs. - Instead of having to copy a preset to a new one, when I need tweaking one of the assigned midi pedals, this "Song...

Hi Gregg You could put a MXR Micro amp in series with the fuzz in the loop. - I think it would do the trick.

In my attempt to get the desired functionality, I think I actually found one more bug. I have put the functionality down into one button with IA cycle ticket on. When this button is on an external switch, the "color" does not work in the third cycle step. You can see this bug on page 4, where I...

Thanks Ron. In my search for this problem, I found that system report does not take the external switches into account? - By the way - great feature with the new search function :-)

In my setup I have "Nova Boost1" and "Nova Boost2" on the external switches on Button page 4 and 5. - This way, the grouping don't work. However, if I copy the same two buttons to Button1 and Button2 on Button page 10, they all work as they should on all button pages? My settings file attached.

I have Mastermind PBC 10.

I think I found a bug in the new release. The button group feature, does not work for the 2 external buttons.

You can configure an IA button to manipulate the current setlist. - Current setlist = None, switches to preset mode. Action type = System, subtype = Setlist.

Sorry - my post was not fotmulated correct. - What I've seen is, when you use Bank up/down at external buttons, they don't repeat - when you use them at the "pbc buttons" they actually do repeat! - As I wrote I use these buttons mainly in "Song mode". - So when I do a gig without setlists, I...