Same as OP, I only save the rjs file named 1,2,3,4,etc in a folder named by the firmware version. If I have to go back to an older version I know what was the used FW. But since the last FW everything is pretty bug free and stable.
Thanks Ron, it's working even with midi merge On and Bidirectional Midi. But it makes surface an older problem I explained here earlier:
I have to check Ignore Incoming PC to on. If I leave it to off, when I'm sending a PC with a IA switch and I want to stay on the same GT preset, the GT switch...
This happened only when I reboot the Axe. And it does it only once, after that it continue to behave with the same error, right scene in the Axe, and wrong on the GT.
This was all working in the Axe-Fx II.
I ungrouped all scenes in all presets. The GT still shows default scene 4 on preset 9, and Axe follows the cc#34 from my iPad and is on scene 1.
I rebooted the Axe and it worked for 3 seconds, and then back to the same mystery.
The GT showed the default scene 4, then I guess the GT polled the...
I did already ungrouped the scenes on preset 9 for testing, as you can see in my settings, no success. Should I nonetheless ungroup all presets to see if it works with preset 9?
I must add that I have cc#34 for Scene Select in the Axe in Midi Setup. If I leave it to None, the scene does not change according to the CC# I send from my iPad.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.