Recent content by The Stever

I’ll try using one output from the rig. why does the PBC6X manual show 2 Output designations on the display? Mine has always only shown 1 output.

It worked!! Sounds awesome. Thank you!! How would I setup to use this rig in mono? Source Audio told Brad Bartosz if I want to run mono I have to disconnect the patch cables going into input 1 and output 1 of the Source Audio Gemini. I bought the Mastermind knowing it can handle any...

I’ll look at that, but what your suggesting implies there would be no signal to the amp connected to the right As I said, there is sound from the right output amplifier - the volume on the amp has to be turned up and it doesn’t sound nearly as full and loud . Also when I turn the volume up past...

My display doesn’t show 2 outputs. regarding buffers. The manual states there are two audio buffers, not 3.

With all pedals bypassed did not fix the problem. Attached is the PB running list sent to me by Brad Bartosz at BTPA. Brad built my PB. I don’t get how to run the right output of the PBC directly into the amp. The PBC only has one Output Jack. Attached is a photo showing the plug connector...

Hello, My PB is setup for stereo. For some reason The amplifier connected to the right output Jack on the PB is not playing at normal volume. I have to turn up the volume on the amp considerably to match the volume level of the left side amp. The amp doesn’t sound the way it should . It’s not...

Two objectives achieved: A. Page 1 display correctly shows 001, Preset 1. B. When I select Presets 1-12 on the PBC, all the SA pedals stay on preset 1. However, I noticed something. The EQ2 PC is set to 0. The lowest setting on the Nemesis and Ventris is 1. Why? Next step - Should I now...

Just confirming you received the settings file.

Please find attached settings file.

So I shut down the PBC for 3 minutes and turned it back on. Now the display shows Song1 Preset 1 and still none of the LEDs are on

Now I have 1 preset and no LEDs are on.

When I go to system menu and press Esit Buttons, it shows Select a Page and Page #1 is blank. Page numbers 2, 3, & 4 are identified correctly as Loops, Loops 7 & Switches. When I select Page 1 it goes to “Edit Page 1”. The two options are “Name” and “Type”. To the far right of Type is Preset. I...

Somehow I just did something on the PBC that affected Page 1 (Presets) Now the display shows Preset 1 Preset 1 But none of the switch LEDs are on. When I press the Function switch it cycles through the pages normally - it goes to Loops (preset 1), loop7 (preset 1) then Switches (preset 1)...

What are the steps to go through each preset in the PBC and subtract 1 from each PC sent to the EQ2? There is where I’m at thus far: 1. Go the setup menu in the PBC 2. Go to Edit Presets 3. Edit Preset 1 (to begin). 4. Scroll down to the device = “Prog EQ” (there is a “1” to the far right of...