GT22 changes loop 1 & function 1??

Flash6969

Active Member
hi all.
Just landed a GT22 to control my Rack Gizmo.
Have completed a factory reset on the RG (just to be safe) & used the RJM editor software to check what’s going on.

Intention; button #7 on the GT will activate IA the loop 1. I understand loop1 to be cc80.

Result: even after loading cc80 into the software editor the GT activates loop1 & function1.
Function #1 should be cc88??

I’ve then loaded cc54 onto button #7; loops 5&6 activate as expected.

Can anyone advise what may be wrong here???
 
File attached & tried to load RG into button #19 on the GT. Same thing happens; both loop1 & function 1 activate when midi cc#80 is transferred to the RG
 

Attachments

  • Flash1.rjs
    1.6 MB · Views: 1
Are you sure you did a factory reset on the Rack Gizmo? It sounds like both the audio loops and function switches are set to start at CC80.

To factory reset, hold Audio Loop 1 and Audio Loop 4 as you power it up. All lights should turn on for a second, then turn off.
 
Back
Top