I'm encountering the same problems as @CaliCaveman.
I don't think I understand how to re-solder the pair of TRS to 2xTS insert cables I've bought.
Would somebody be able to explain how to do this in a little more detail please? I'm pretty handy with a soldering iron as long as I have a diagram...
I've recently added a Mobius to my rig, which I have set up pre/post and true bypass. Pre signal goes into Loop 1 which I now leave open all the time. The Post signal goes directly from the pedal to my amp's FX loop. I have it set up this way so that I should be able to simply bypass the Mobius...
Sorry just the toggle function. I seem to have made a work-round by allocating a new CC number to the P/B switch and at the moment it is working.
I suspect I must have made a mistake initially as I can't see why any CC number would be better than another!
Hi there
I wondered if anyone might be able to help. I'm trying to replicate the behaviour of my TF to toggle between play and bank modes using the PBC. On the physical pedal, this requires pressing and holding the right foot switch for a couple of seconds until the mode shifts (and then...
I wondered if it would be possible to use the Expression stored settings (created on the Global page) on the preset page instead of having to overwrite the pedals per preset every time?
I know these can be attached to an IA switch but it might be easier on the preset settings page as well...
The problem was that I had not turned the delay time selector in advanced config all the way to zero, so I had incorrectly selected the MIDI channel.
Now working splendidly.
Carry on...
Hi there
I'm tearing my hair out trying to get this freakin' delay to work with MIDI.:mad:
I've connected the Empress Echo to the MB2 using both TS and TRS cables - both are the same (non-functional). I've configured the Echo's control port setting to listen to MIDI, channel 2 (advanced...
Hi there
I've tried unsuccessfully to program the PBC10 so that my fuzz pedal stays on when I change between presets. I've tried turning off "send on preset change" and "update state on preset change" in the button commands but it doesn't seem to work for me.
What am I doing wrong?
Appreciate...
Hi Ron I've submitted a support ticket with a file copy of my current settings - hope this is the right thing to do.
I've also done a deep clean with the utility file, rolled back the firmware, but none of these measures have helped.
I've also created several dummy MIDI devices from the PBC...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.