I've never been happy with amy pedal delay and have used fractal in the past in the 4cm for effects only but have sold all my fractal stuff. Just wondering if the PBC can tap into the HX effects for effects and still change amp channels?
My editor pre set is in my post 'Loop 7 not working' to take a peak at how it's set up. I followed the steps in the vid you sent me a couple of years ago Ron. Changed all groups to 1 int he 'Switches' page then on the Presets/Audio page I am assigning the amp channels and effects. The PBC is...
I think I got top 7 to work, why won't this file allow me to change amp channels? I have it set up for a 2 ch amp buttons one on the PBC is set for amps ch1 and button 2 for amps ch 2 but the amp stays on ch 2 for both buttons. I assigned them Both to Group one on switch's/Buttons page then in...
I keep trying to get my Decimator gate working. When I engage loop 7 in the file attached it has not sound then when I turn it off in the Audio part of Presets page it has sound. What am I missing in the file set up?
Thanks!
To clarify the manual does not say what the Out put A or Output B go to
That’s either to the Return of the Loop or to the Input of the amp
See pic from rear panel please clarify:
Does Out 5/6 go to Input -Front of amp or???
And the OUTPUT A or B to ???
I’ve got In7/10 going to Send of Loop but the manual does not say which one goes to the Return
it says Out 5/6 goes to In put of the amp
-that’s not the Return correct? I take InPut to mean In put on front of amp
Sooo which jack goes to return?
I have a 2 ch amp I would like to change Chanel’s on and loops assigned as follows:
Pre
1 OD 1 for ch 1 of amp
2 OD. 2 for ch 2 of amp
3 Wah
Post
7 Delay for Midi
8 Reverb
I Would like Loop 1,7,8 on for buttons one and two for channel 1 Of the amp and
Delay midi preset 1a for button 1 and...
On full time, unless that cuts off notes when playing clean?
Currently I have it routed: Decimator In to Send of amp. Dec Out to return of amp Guitar In on pedal is deceiving my wireless guitar signal and on the other side of the pedal the Decimator Out runs to guitar In on PBC
Those 2 scenarios sound similar
On the DD I have Bank 1a with a rhythm delay and I would like to assign it to PBC far left too and bottom buttons -my 2 rock tones
Bank 1b on the DD would be assigned to button 2 on the PBC for solos and to a few other spots
How do I do this in the editor...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.