1/4" interface cables with non-supported amps

A

AdeWalker

Active Member
Is there a guide anywhere to how to setup the MAG and 1/4" interface cables for use with "non supported" amps? For example, momentary vs latching, stereo vs mono connections, etc?

Thanks.
 
We haven't done anything like that yet, but if you have questions about a specific amp you can ask it here and should be able to dig up the answer.
 
That's a pretty simple one - a single latching switch, I believe. All you need is a single 1/4-inch plug, and set up by powering up while holding 8 until the lights come on steady. Then release 8 and press 1. (Or on RG-16/ Rack Gizmo, hold Function Switch 1 on powerup).
 
Perfect! Thanks.

Incidentally, when changing the configuration of the MAG during power-up (as described above), does this delete the presets already in memory?
 
You must log in or register to reply here.
Back
Top