Wet/dry/wet 2 amps Axe2 and line mixer

[Cflanary]

Please help me figure out how to pull this off
1. Running two amps. Fender DRRI and Cameron Atomica both with line out boxes to get a dry signal.
2. Using the Rack Gizmo and the mini line mixer
3. Using the axe2 primarily for fx but would like to use it like a third amp if possible
4. Taking the outputs from the axe to a matrix1000 and two mesa theile cabs for the wet channels.
5. Have a few pedals that will go in front of the amps
6. Controlling it with a GCP

I am not sure how to pull this off and would appreciate any tips...

 

[rjmmusic]

Run the pedals in the first 5 loops of the Rack Gizmo.
Connect Out 1-4 to In 5, Out 5 to In 6, Out 6 to In 7
Connect send 6 to the first amp input, send 7 to second amp's input, send 8 to Axe Fx input
Line outs from the amps, as well as output 2 of the Axe-Fx go to the line mixer
Line mixer output goes to Axe's input 2 (mono)
Axe output 1 to Matrix input (stereo)

This will allow you to switch between three preamps (including the Axe) and the dry signals are mixed down, run through the Axe and out the wet speakers.

You'll need to add the FXL block to each preset on the Axe-Fx. Anything before the FXL block will be part of the preamp section, everything after FXL will be the wet effects.