Recent content by ChrisConteGuitar

My Ventris seems to work fine. I just send PCs to select presets on the Ventris and Nemesis. Ventrus Preset MIDI Engine Notes Preset 1: 0 Room Room 1 Tight Reverb Preset 2: 1 Plate Plate 1 Presense w/Tail Preset 3: 2 Room Room 3 Perfect Room Preset 4: 3 Hall Hall 3 Hall of...

Ahh...so nothing to worry about?

Hi Ron, and everyone. For some odd reason, I did something to cause my GT/10 to generate this SysEx message every 3 seconds. The only change I made today is that I added a new device (FM3 by Axe Effects), and I started creating some new presets to call up the FM3 presets/scenes, and I changed 4...

No why didn't I see that....thanks Ron. Bob's your uncle...

Ahh..interesting. So, I set up a couple of "preset" buttons to change presets on the EQ2 and I see the MIDI going through and the EQ2 switches presets as expected. That is obviously done in the preset page under "PC Messages" What is not working is the "on/off" MIDI command that I programmed in...

Yes, that box is checked. See attached. This is also an IA function where I use the HOLD function to access the Tuner. Prior to adding the EQ2 Boost (via MIDI), I had an Xotic SP Booster in Loop 6 of the Mini Effects Gizmo, and I controlled that previously with this IA button. IT worked fine on...

I know this is a hardware and software change, but it would be nice to scroll up and down (via a rotary encoder) through songs quickly to select the song. Because I have 80+ songs, getting between "Brass In Pocket" and "You May Be Right" is a tap dance that is no fun. Obviously, it's not a...

Hi Ron, I recently added the Source Audio EQ2 pedal as a boost. I assigned it an IA button and I send a CC number to toggle on/off via MIDI. It works find when engaging the IA button. However, when I assign the IA button to a preset, the IA button appears to "turn on" (color changes), but it...

Hi Ron, here is my GT10 file. Have a look and perhaps you will see something obvious.

Yes. I’m traveling this week so I will send on Saturday. Thx Ron.

Hi Ron. Under the "Hold Function" menu in the GT editor, I have 2 actions: 1.) MEG X: Tuner / CC Toggle #119 off:0 on:127 2.) System / Tuner The way it works is when I "Hold" the button, and enter "Tuner" mode. Then, to exit, I "Hold" the button again and it returns to the IA mode for the...

I am having a issue with the connected MEG x unmuting when I exit the tuner mode. I set up a Global IA (my Boost pedal) as a "Hold" button and I just the hold function to enter into Tuner mode. This seemed to work fine at first. However, lately, when I enter "Tuner Mode", obviously the signal is...

I tried it again this morning, Ron, and it works. I even assigned the HOLD function on this IA switch and added the Tuner when I HOLD the IA switch. Thanks for your guidance

Can't seem to figure out how to make the tuner work. Perhaps you can look at my file. See attached.

I know what my problem is....I have assigned the devices as "Mini Effects Gizmo" and not MEGX. i will change that tomorrow