Recent content by Sam

Hi, Recently transferred a new setlist over but for some reason, the songs that get pulled aren't correct. Some of the songs in the setlist will pull up the correctly numbered song but then some of them will pull up the next numbered song, eg song 3 should be selected but it pulls up song 4...

Could you post your diagram please?

Sweet, thanks. The send jack only sending and return only returning helps clear it up. Wanted to get it down before I went ahead and soldered my cables.

I'm a bit confused with the wiring. Let me see if I've got it correctly, and please correct me if I don't! My initial guess was to plug in the TRS plug to Loop 4 and have the tip/ring connected to the pedal that I want in Loop 4 however it seems like that is not the case. So is the correct...

I have a RJM PBC/6x and I've set it up to where Holding my Bank Down and Bank Up button will take me to my 3rd and 4th pages respectively. To get out of these pages, I have the Function button set to IA->Page->Page 1. The issue is after I access one of these pages, pressing the function button...

Just tried it, found nothing

Hi, For some reason, when I activate presets that have Loop 3 engaged, it automatically sends a CC #3 of value 127 to my Midi Device Ch 5 even though there is no CC action set. It does this even when I unselect the device for the preset and also when I select the device AND create a CC Toggle...

Thanks, that did the trick!

Hello, Would the following scenario be possible, and if so, how can I create it? -Hold down a button for ~2 seconds -Turns on Tap Tempo function for this button and stays as Tap Tempo until -Hold down the same button for ~2 seconds to revert to original button function Thanks in advance!

Hello, I recently purchased a PBC/6X and am using the default tuner function but it doesn't mute my signal. The default IA actions are as follows: System / Tuner Audio / Output #1 off:ON, on:OFF Audio / Output #2 off:ON, on:OFF any help would be great! I don't have any weird routing for the...