Signal chain, but VP is main question

[Frozone]

So I just brought this home and I'm coming from a Disaster Area setup...

As far as setting this up (ins/outs) what would you suggest? I have Compressor (Send1), Pog (Send2), OD1 (Send3), OD2 (Send4), OD3 (Send5), OD4 (Send6), Boost (Send7), Volume Pedal, then Tremelo before going to Timeline & Bigsky... But where do I put the VP in/out? I think I read Out5/6 & In7/10, but I have nothing in Out 1-4, In 5-6, Out 5-6 at this point. Is that ok? That would also technically put my boost after the VP, correct?

Another question, I've seen guys using IN/OUTS for Timeline & Bigsky.... With my Disaster Area Setup, I just went mono out from the DPC Controller to the Timeline-Bigsky-Interfacer out to amps.

Oh! Have we also figured out how to change/upload Strymon presets to TL & BS through the PBC? I have a MIO Connectivity USB/MIDI cable...

What would you recommend? Thanks guys!

 

[Terry Richalds]

Here is what I do. I'm sure putting your Boost after your volume would be fine. My Boost and Volume are in Out 5-6 to In 7-10

 

[Frozone]

Nice! Thanks Paul!

 

[Meanoldfireman]

That should work fine. I have a Slide rig in 7, so I ended up with the Volume pedal on the output. Not ideal, by I don't use it for swells (except with the slide rig). It's more so I can adjust the volume. As for the MIDI connections to the Strymon boxes, there's a whole thread on that.