Brand new MMGT16, only few days old, before starting to configure, let’s factory reset and update to 4.3 release.
Out of the box, the unit appeared to be functioning as should, no issues found.
Powered directly from the included powerbrick.
Update went fine until per row update started and failed at the middle row.
Row 2 first lcd showed progress bar, but update failed for some reason.
GT16 was not touched or interrupted during update.
Some lcd’s on row 2 showed a repeating id= pattern from top to bottom during row update, with last line something like
“Press key for id=[number]”.
Overall the update to 4.3 completed, and the GT16 boots fine, but row 2 lcd’s are blank, and all switches on row 2 do not
function. Reboot, nope.
Downloaded 4.3 again, md5 is consistent, so corruption of the downloaded software is not likely.
Downgraded to 4.2.3 which should do factory reset, it did but row 2 still blank and switches not functioning.
Installed 4.3 again, row updates not attempted by update, no change/improvement, row 2 unusable.
Also tried another USB stick as suggested elsewhere, just in case, as expected no change/improvement.
I now have a pretty expensive brick.
Pls advise.
Out of the box, the unit appeared to be functioning as should, no issues found.
Powered directly from the included powerbrick.
Update went fine until per row update started and failed at the middle row.
Row 2 first lcd showed progress bar, but update failed for some reason.
GT16 was not touched or interrupted during update.
Some lcd’s on row 2 showed a repeating id= pattern from top to bottom during row update, with last line something like
“Press key for id=[number]”.
Overall the update to 4.3 completed, and the GT16 boots fine, but row 2 lcd’s are blank, and all switches on row 2 do not
function. Reboot, nope.
Downloaded 4.3 again, md5 is consistent, so corruption of the downloaded software is not likely.
Downgraded to 4.2.3 which should do factory reset, it did but row 2 still blank and switches not functioning.
Installed 4.3 again, row updates not attempted by update, no change/improvement, row 2 unusable.
Also tried another USB stick as suggested elsewhere, just in case, as expected no change/improvement.
I now have a pretty expensive brick.
Pls advise.