Timing Settings: Do Not Repeat

[ataglianetti]

Is it possible to adjust the timing settings so that a message is only sent once, without repeating if held?

I'd like to have a single button that, when pressed, sends a Dev PC + message, but when held, sends a Dev PC - message.

When holding the button to Dev PC -, the PBC keeps sending the Dev PC - message until the button is released. Is there any way to make it so the message does not repeat on a button hold?

 

[rjmmusic]

Set the First Repeat parameter to a number that's higher than the Hold Time parameter. It'll trigger the hold function before it starts repeating.

 

[ataglianetti]

Thanks Ron, works like a charm!