W/D/W PBC Radial Headbone VT Fryette

builttorock

New Member
Can someone provide advice on the best way to connect this up using a RJM PBC

Guitar -> Radial Headbone VT "Input Direct" or do I go into the PBCx and then out of that into the Radial?

Radial Headbone VT From Amp Input 1 -> Bogner Ecstasy Input
Radial Headbone VT From Amp Input 2 -> Boogie IIC+ Input
Bogner Ecstasy Speaker Out -> Radial Headbone VT "From Amp 1 Output"
Boogie Mark IIC+ Speaker Out -> Radial Headbone VT "From Amp 2 Output"
Radial Headbone VT "To Speaker Output" -> Fryette Power Station PS2

PBCx Function Switch -> Radial Headbone VT to switch between amps.
PBCx Function Switch -> Channel Change on Boogie IIC+

Tuner Output from PBC

Before the Amp(s) Input:

Xotic SP Compressor
Boss SD-1
Tube Screamer
EVH Phase 90
EVH Flanger
Also where would a volume pedal go in this setup.

Effects Post Pre-Amp [Wet L/R Cabs w/Dry Mixed In]:

Stereo Chorus
Stereo Reverb
Stereo Delay 1 Short
Stereo Delay 2 Long

Fryette Power PS2 Station -> 412 [Dry Cabinet]
Stereo Power Amp -> Wet Cab 1 [L], Wet Cab 2 [R]

Other Info:

I am using an Axess Electronics Bogner Ecstasy Midi Channel Switcher to handle the channel switching on the Bogner.

Appreciate the help and and additional recommendations such as ISO transformers etc. I took a stab at it with this diagram. Can someone vet it for me and provide corrections

thanks
Mike
 

Attachments

  • Pedalboard PBC10.pdf
    150.6 KB · Views: 2
Last edited:
That looks good to me. The Head-on is exactly where it needs to be and the Power Station is the other key piece to get the dry signal from the selected amp.
 
Hello RJM and thank you for the reply. I realize that is not a true dry signal because the pedals in L1->L4 are going to be in front of the Bogner/IIC+ but not much I can do about that with this setup.
 
Generally, the way you're doing it is preferable. You don't typically want the wet side to be based off of a completely clean signal if the dry side is overdriven.
 
Back
Top