RG-16 with 2 amps and 2 stereo effects? Possible?

Hello Tim here again with a new project I have been dabbling with.

I can't get it right. I want to use my Eventide Pitchfactor and Line 6 M9 in stereo with 2 amps with the RG-16.

I want to be able to use the 2 in stereo and also be able to switch my amps.

Is this possible?

- Tim
 
that´s possible!
did nearly the same thing a few years ago. it´s a bit complex to hook it up, but possible in the end.
you´ll need two loops for each fx-pedal, if you want to switch them both in and out.
for the two preamps you´ll need two loops as well.

this was my setup a while ago....two amps in stereo with A/B select of the preamps (no parallel setup!)
the harmonizer was switched in / out as i needed it, the g-major was always in the signal chain.
just look at it, to get an idea of how to set up yours.

joes_setup.jpg
 
You're going to struggle without using the loops. Simply because you've asked for two things - you say you want stereo effects AND you want to switch amps. Without using the FX loops, you've got one or the other option. Stereo effects will have to feed both amps at once (you can't get stereo from one amp). If you're switching amps, each amp will only give you mono.
 
Back
Top