Search results

Could a “hi lighted” section be able to be reordered alphabetically?

I just tried updating to firmware 5.3 again and again ended up with a corrupted groups section. I don’t know if I’m the only one with this issue. Downgrading to 5.0 and installing backup settings gets me up and going. When I have time, I’ll try upgrading again, converting a backup settings file...

Yeah, when I saw that I figured it was a problem. I do have back up settings files on my thumb drive as well. Thanks.

I read the device for my settings (included) and I'm sharing a screenshot of my editor. Take note of the button groups section.

No, it began as soon as I updated the firmware. The button response was very slow at first and then they stopped responding entirely. No modifications to my setup which has been running for years now. I was only able to downgrade the firmware by powering up with 1&3 depressed and going...

A further update. I reinstalled the 5.21 firmware and the odd behaviour returned, back to 5.01 and all was normal. I reinstalled 5.30 and the odd behaviour returned. I'm now back on 5.01, no issues.

No, but I just downgraded to 5.0 and it seems to be back to normal. I had previously been running 5.21 with no issues.

I don’t know if this is specifically a firmware upgrade issue or not, but it occurred immediately after upgrading to 5.3. when powering on, it takes a few seconds after the splash screen reverts to my preset screen for the LEDs to illuminate. My button presses react sluggishly and stop having...

When I create a setlist with the possibility of adding a non planned song I insert a generic “song” every 5 songs with a clean, dirty, crunch and lead tone.

I use the same with the exception of the SPS5s, I use the G&H TS stubbies. I appreciate the strain relief.

WooHoo! I like your enthusiasm.

It looks like a European power bar.

Of course, I had done that, but the change was kicked out and didn't function so I tried the Performance switch which worked as a latch and i Got frustrated. Thanks.

I feel like a bit of a Dufus. I had to reset my H9s a while backend I just noticed that I'm no longer able to control them with my Mission RJM pedal. I have the CC set to 17 in the Expression Pedal Settings, but I'm not finding the Expression Pedal MIDI Mapped in my H9 Control app. I'm sure the...

Thank you.

Thanks for the quick reply. I've mapped the Active/Bypass to CC 10. I use the H9/Switches button at the top of Button Page 1 for switching as well as a MIDI Device control page on Page 4. It worked for years previously, I recently reset my H9 for an unrelated reason and it hasn't worked...

I recently reset my H9, and ever since I need to press my button on my PBC twice before it toggles between Active and Bypass. This is both annoying and screws up the coordination with my button's on/off colour. I'm figuring that I inadvertently screwed up a setting, any ideas?

Thanks for the quick reply. Here are the 2 files

I just updated my PBC 10 to firmware 4.61. Now when pressing a preset button, after briefly having sound, my rig goes silent. Upon pressing the same preset button a second time, I get sound like I normally would. Returning the PBC to firmware 4.5 and updating the settings, everything works as...

Upper right. That’s what I needed. Thanks.