Everything was solved with a restart of the device, I may have done so many tests that at some point a conflict was created, I have redone the presets and everything has worked from the first moment, I apologize for so much inconvenience, honestly I am very happy with it MEGX I have achieved all...
Hello, I practically have everything working although I still have a problem, I think the last one to solve. For some unknown reason LOOP 12 does not turn on , I find the delay very strange , which is on LOOP 6 and shares the same wires , it does work , so I think it has to be some configuration...
Ok, I already found the cause of why loop 6 always turns on, it's because in my controller I was sending CC #85 so that the EVH 5150 loop is activated but that message also activates loop 6, I changed that message to another value CC # 120 to avoid the conflict and everything is solved.
It was...
Hello, MEGX has arrived and after a few days it starts to work, finally I have also put a noise gate so I have needed to enable another loop, due to the cables I had I have enabled loop 12 and finally it has been as follows:
- GUITAR STEREO OUT ( "Y" cable ) -- Pick-up to In MEGX // -- Piezo to...
Thanks, changing the order is a good idea, but I'll try entering the loop without a preamp, in general I like how the piezo sounds direct to the line, that's if I've never tried it in an amplifier loop, I'll also try putting a compressor before.
Another way that could be used is to connect the...
A MEGX is on the way, I read the manual and it really blows my mind, I have a JP15-7 that I will use together with an EVH 5150 III 50W, I am trying to figure out the best way to do separate guitar scenes for aggressive rhythms and others for acoustics with piezo .
The first option that comes...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.