Hi Ron,
I've got an error in a few select presets where the buttons on the external switch don't behave as expected.
I've got 2 switches set with a hold function on each to designate preset menu and preset number (hold) on one switch and tuner and page menu (hold) on the other. I have both of...
Ahh bugger, I saw the Voodoo Lab Pedal Power AC, which gives up to 1200ma AC but I dont think it would be any good for the GT as it needs DC if I'm correct.
I'm trying to consolidate my rack and get it a bit neater as I've got a wireless pedal strapped in on a shelf with it's own 9v supply and then a 12v supply feedings my GT16 through a 5-7 pin cable plus two power supplies for rack gear.
So is it possible to power my GT16 from a power brick that...
I got the Best-tronics 5-7 pin cable, soooooo much better.
In regards to having the GT powered through the cable, I've noticed that if I have the cable powering it and plug in the AC adaptor (just the connector without the wall plug so it's not actually powering it) that it cuts the power to...
Is this something that can be incorporated into the preset list in the MMGT Editor? When dragging presets, the pc number changed to the corresponding slot that it is move to and likewise for any others that have shifted positions? Although unknown to me there could be reason it's as for how it...
Yeah, I saw it last night as I was typing out the post and it does exactly how you described it above. It's not too bad as I've got it set on a hold button so I only hit it when I need to but it's just something I noticed.
I just updated mine from 3.2.3 to 3.3.1 and though heck why not just update to 3.4.1. Here's a few things noticed:
Whenever I'm higher than bank 4 and hit the bank down button, it goes down to bank 4. It works fine for the first 4 banks but then anything above makes it go to bank 4 selection...
What about an option for buttons to override the stored state of a block when changing scenes in an Axe fx?
Like how a normal guitar pedal stays on until its turned off, but only limited to a checked button that only works within scenes. Like turning on a pitch shifter on in one scene for...
Update: I checked the settings and all were as mentioned above. Then I tested the bidirectional and that doesn't work.
I will take it back.
I wouldn't recommend the rocktron cable, the best tronics seems the way to go if anyone else is looking.
Seems to be just the tuner with this new cable. I'll have to test if the other bidirectional functions work on the GT when I'm home later.
The tuner works with my other cable so I assume midi bidir must be on, but I'll also be sure to double check the settings.
So I got this cable, and everything works except for the tuner...
I'll probably end up getting one of the best-tronics cable in the future but I'm curious as to what caused the tuner not to work.
Could it be one of the pins is not wired correctly? I wouldn't know what information runs on each pin.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.