Search results

  1. R

    Setting outputs A and B as independents

    The "independent" feature for audio loops is very useful. It would be great if both outputs could also be set as "independent".
  2. R

    Question about stereo pedals

    Hi there. I'm running some pedals in stereo at Loops 7-10 and I'm a little confused about wich cables I have to use and how to set Stereo/Mono buttons. Loop 7 - Chorus (in series) mono in/stereo out Loop 8 - Delay (in parallel) stereo in/stereo out Loop 9 - Reverb (in parallel) mono in/mono out...
  3. R

    PBC/10 Buffers

    Hi! When running line level signal into loops 7-10 (in parallel), is it necessary to turn on audio buffers 2 and 3? Thanks
  4. R

    Prostage Remote WahWah

    Is it possible to use PBC as an interface between Prostage System Mananger Software and Remote Wah?
  5. R

    Independent Loop

    It would be great if all audio features (parallel/series, buffers, outputs, etc.) could also be set as "independent".
  6. R

    Timeline and expression pedal

    I use PBC to control mix knob via an expression pedal and to send Preset Change messages to Strymon Timeline. The problem is every time I change preset on Timeline the expression pedal state is lost and I ve got to move the pedal again. Is there any way to send a cc message to timeline with the...
  7. R

    How to make an audio loop ignore preset changes?

    I use a solo boost pedal in loop 6. There is an IA button programmed to turn loop on and off. Every time I change preset, audio loop 6 is turned off. Is it possible to configure it to not change its state (on or off) while moving through presets?
Back
Top