Search results

I got it directly from you about a year ago while I was in New York. I know some local techs if you could send me the information needed.

Sorry, I did that wrong. Tip is about 0.95 and ring is barely anything.

The tip is about 1.6 and the ring is close to zero

I have a multimeter alright

Ireland

Hi Ron, I got a custom made 2 button switch done as per your schematic in the manual and this is doing the same thing. I don't know what I am doing wrong. The cables are fine. I basically have 2 extra buttons - one as a stop/clear for my BOSS looper which isn't working and another for my BigSky...

The cable is fine too. I tried a few different cables and it happens with any. I really don’t know what’s happening.

It’s definitely momentary and the correct specs according to the PBC manual

Hi all, I'm having a weird issue using an external dual switch with the PBC. I bought a Mosky Dual Switch recently and I wanted to basically use them as 2 extra buttons for the PBC. I originally had them setup to be a hold for the Big Sky and a Hold for the Timeline. The thing is that it worked...

Nevermind, I got it working.

Hi, I recently got a Mosky Dual Switch to use as an extra couple of buttons on the PBC. I can not get it working the way I want. I don't know if I need to enable it or not but I know it is working in some fashion as when I edit the "ext Switch Overrides" under the presets button it will do what...

By gum that did it! Thanks!

I tried that too

That actually makes it worse. It causes the function to latch

Hi, I am trying to use the CTL 1 out as a footswitch that emulates a BOSS FS-5U. I have it working to a point. The issue I have is that when the PBC first powers up or when I change a patch I have to press the switch on the PBC twice and every other time it works with one press - like it should...

I got it working. For my initial preset I have it sending cc69 with a value of 0 to make it start on snapshot one, then in the alternate preset I had to send a midi cc 69 with a value of 8 and another midi cc69 with a value of 9. This has it working like a boost

Just a normal preset button. I want it to change snapshot on second press, I have the cc command to toggle the snapshot setup in the alternate preset I have it pointing to for second press

Hi Ron, I'm still pulling my hair out over this. When I program the PBC to send the required CC command to toggle snapshots and send the changes to the PBC via the editor, the first time I do a 2nd press to test the settings everything works as intended but then any other time I press the button...

How do you handle something like a boost though? If I want to turn on a loop on my Mastermind and also activate a snapshot with a single button press then that's not ideal.

I don’t have any IA buttons set up. I don’t know where I’m going wrong. If I set the HX Stomp to toggle snapshots it will work when I’m in snapshot view just by doing a second press of my currently selected preset, even when I have no midi commands programmed for the HX Stomp at all. The thing...