I adore all the new features in the update, especially the new Alternate Preset, it's brilliant!
However I did notice that the target for the alt/pre is the number of the preset chosen, rather than the preset itself. This has already caused an issue for me when dragging presets around. For example let's say I only have 6 presets,
1. Intro
2. Verse One
3. Chorus
4. Verse Two
5. Bridge
6. Outro
Let's say I had Verse Two as the target alt/pre for my Verse One preset. Let's say I drag the Bridge preset to the top of the list so it shows this:
1. Bridge
2. Intro
3. Verse One
4. Chorus
5. Verse Two
6. Outro
Now because preset numbers have changed the alt/pre for Verse One has now become the Chorus!
This could become an issue if there are multiple alt/pre's in use, adding only one new preset into the list would disrupt them all and require you to manual check each one.
Could this perhaps be tweaked slightly so that the target for the alt/pre is the preset itself rather than it's number?
However I did notice that the target for the alt/pre is the number of the preset chosen, rather than the preset itself. This has already caused an issue for me when dragging presets around. For example let's say I only have 6 presets,
1. Intro
2. Verse One
3. Chorus
4. Verse Two
5. Bridge
6. Outro
Let's say I had Verse Two as the target alt/pre for my Verse One preset. Let's say I drag the Bridge preset to the top of the list so it shows this:
1. Bridge
2. Intro
3. Verse One
4. Chorus
5. Verse Two
6. Outro
Now because preset numbers have changed the alt/pre for Verse One has now become the Chorus!
This could become an issue if there are multiple alt/pre's in use, adding only one new preset into the list would disrupt them all and require you to manual check each one.
Could this perhaps be tweaked slightly so that the target for the alt/pre is the preset itself rather than it's number?