Audio delay with PC changes on Strymon Deco V2

C

chriswrate

New Member
Recently started getting gaps in audio when banking up or down through presets on the Strymon Deco. There is no delay in the PC when a preset is engaged that changes a PC on the deco, it only happens when I do a device pc+ or - on the Deco page. I have a similar page layout for the Flint and don’t encounter the same problem. Not the ends of the world but just wondering what could be causing this?
 
I'm not sure why that would happen. All a Device PC-/+ button does is send one PC message. It shouldn't be any different than sending a PC any other way. If you switch through presets rapidly on the GT, resulting in different presets being sent to the Deco, are you sure that there's no delay?
 
No delay at all when preset changing. The timing also varies. Could be a couple seconds and sometimes is close to being instant. I’ve gone through my midi settings on the deco to be sure something didn’t get changed and tried running it through a different midi channel. Again, it’s not the end of the world as this is not how I’ll be using it in a performance. Just thought it was odd that it was occurring when sorting through sounds to save to a preset.
 
If you're only sending a PC to the Deco, there has to be going something going on in the Deco. The GT has no audio going through it and only one PC is beng sent. You might want to ask Strymon about it.
 
My apologies. I must have clicked on GT discussions. This is for the PBC10. Issue might lie with the Deco either way.
 
You must log in or register to reply here.
Back
Top