Effects Gizmo: Question about using a single stereo loop after 4 mono pedals

K

Karsten Fliegner

Member
Hello, I'm new to the forum (though a long-time Gizmo user, and moderately long-time Mastermind PBC user). I've been using the Effects Gizmo for 4 mono effects, but now I have a Meris Enzo I'd like to place in a stereo loop.

My question is: do I need to have anything in the loops between 4 (my last mono effect) and 9 (where I plan to place the stereo Enzo)? Put more simply: how would one go about routing 4 mono and one stereo effects?

I couldn't find my answer in the FAQs, or by searching.

Thanks in advance,

Karsten
 
Sorry, I'm confused. I had assumed (probably incorrectly) that I would take a double-TS to TRS cable from the R and L out jacks of the Enzo to In 9, then a TRS to TRS cable from Send 9 to the Input jack on the Enzo. If this is not the case, then how do I route the pedal to the loop?

Sorry again if I'm being obtuse.
 
Last edited:
I've re-read the Gizmo manual and now am even more confused. If a TS to TRS cable (I think that's what you meant above) goes from CS Out (mono) to In 9 (stereo), what goes into the other 3 jacks labeled 9? Am I right in thinking a TRS to TRS cable from Send 9 to the input, then a TRS to stereo-split (double TS) from Return 9 to the R and L output jacks on the Enzo, and finally a TRS to TRS from Out 9 back to the Axe-Fx III I/O loop?
 
You have the connections to and from the Enzo correct. I made the assumption that you want all of the pedals in series. If that's the case, a TS to TRS cable will be needed to convert from the mono signal coming from loops 1-8 into a stereo signal needed by the Enzo and the Axe-Fx return.

Regarding the Axe-Fx, as far as I can tell, you'll need an insert cable (TRS to 2 TS) to connect back to the Axe-Fx's return.
 
You must log in or register to reply here.
Back
Top