Gt16 and BTPA midi cable

[Boltfanfml]

Got my BPTA

AS-MSTRMBIP-XX cable for my Kemper rack last week and cant get my presets to read on the GT16. The preset boxes stay dark. The bank up/down light up and change the preset bank. But no presets are shown. I have other IA buttons mapped to Device 2 (Chauvet Obey) to change light presets and that device is controlled via the Kemper Midi Thru jack. That device works just fine and is getting the midi commands from the GT16 thru the Kemper. As soon as I unplug the BTPA cable and use 2 midi cables and the power supply, it works fine. Any ideas? Is there a setting I am missing to account for this single cable setup? Thank you - Justin

 

[is9582]

Do you have bi-directional communications enabled on your GT? If not, it would seem that may be your issue.
Good luck
Lee