Short question! about the MEG X

[PL Guitarsystems]

Hi Guys dos anybody has a block diagram of the MEG X ? Thanks in advance Paul Lenders @guitarsystems

 

[rjmmusic]

Sorry, I've never drawn one up. But it's pretty simple. To give you a quick answer:

In 1 connects through a buffer to the switching matrix
In 2 connects directly to the switching matrix
Loops 1-6 sends and returns are all connected directly to the switching matrix
The output is directly connected to the switching matrix
The switching matrix can connect any input to one or more outputs, under software control.

 

[PL Guitarsystems]

Hi Ron, Mario. I just wanted to know if I can use only the sends on the MEGX. and the in and out put......I’d like to use it to control the sends of multiple studio effects, such as the 2290 and H3000, and then route the outputs of those effects to the mixer returns. Or do I need to use a Y-mono cable for that? Thanks in advance.Nice Regards Paul

 

[rjmmusic]

Yes, in all of our switchers, you can use just the sends, leaving the returns empty. Each loop then effectively becomes a splitter when activated, sending the signal out the send jack and back to the switching matrix for the next loop.