Two parralel paths

[Kingston]

I`d like to set up my PBC/10 with parallel paths for two amps. So that the input goes to through loop 1-6 and then to out A, and parallel to this, the clean input also goes loop 7-10 and then to out B.
I made a little drawing of this.

Is this possibile, and how can I do this?

Thanks

 

[rjmmusic]

The first case isn't possible, because there's no insert point between loops 2 and 3, so you can't split the signal at that point.

The second one is possible. You would need a splitter (preferably a buffered splitter) to split the input signal to go to both In 1-4 and In 7-10. Out 5-6 goes to the first amp and Output A or Output B would go to the second amp. I recommend turning on the Mono Output switch and using Output B because you can switch in the isolation transformer on Output B if you end up with hum.

 

[Kingston]

Thanks for this very useful answer