vertigocycles
Member
I have a situation that I hope someone can help me with as I might not be thinking about this in the correct way.
I'm wiring up my Effect Gizmo and am stuck on my TC2290 being last in the chain as is my preference. The two units before the 2290 are proper stereo in/out. If I use a ts cable into the 2290, I'd lose one side of the stereo signal. If I use a TRS to TS, the signal would combine the left and right and I'd lose the stereo signal. Is there a clever workaround for this that doesn't involve a mixer?
Before trying to integrate the Effect Gizmo the path went like this:
preamp send (mono) to 2290
2290 stereo loop (mono send, stereo return) into TERC (mono in, stereo out)
TERC outs to TC1210 (full stereo)
1210 to RSP Intelliverb (full stereo)
RSP outs to 2290 loop returns (stereo)
2290 outs into preamp returns (stereo)
This setup works, but the switching is a little clumsy. Perhaps the path of least resistance is to use the FX Gizmo final loops for switching the non midi FX
I'm wiring up my Effect Gizmo and am stuck on my TC2290 being last in the chain as is my preference. The two units before the 2290 are proper stereo in/out. If I use a ts cable into the 2290, I'd lose one side of the stereo signal. If I use a TRS to TS, the signal would combine the left and right and I'd lose the stereo signal. Is there a clever workaround for this that doesn't involve a mixer?
Before trying to integrate the Effect Gizmo the path went like this:
preamp send (mono) to 2290
2290 stereo loop (mono send, stereo return) into TERC (mono in, stereo out)
TERC outs to TC1210 (full stereo)
1210 to RSP Intelliverb (full stereo)
RSP outs to 2290 loop returns (stereo)
2290 outs into preamp returns (stereo)
This setup works, but the switching is a little clumsy. Perhaps the path of least resistance is to use the FX Gizmo final loops for switching the non midi FX