Guitar to either MXR Dynacomp or Phaser out to amp directly with no PBC - no audio volume drop.
If I put either in loop 7 (which is fed directly from buffer 2) of PBC then again no audio volume drop. I am assuming both pedals must have impedance requirements that buffer 2 is meeting.
If I put them in any other loop including loop 1 in front of buffer 1, then significant volume drop.
Whats so special about loop 7 and buffer 2?
My other pedals are ok volume-wise in any of the loops and I am ok leaving the phaser in loop 7 to take care of its volume drop issue but I need a loop for the dynacomp without volume drop. (Again loop 1 with buffer 1 feed still volume drop)
Any thoughts on how to resolve and whats happening here?
If I put either in loop 7 (which is fed directly from buffer 2) of PBC then again no audio volume drop. I am assuming both pedals must have impedance requirements that buffer 2 is meeting.
If I put them in any other loop including loop 1 in front of buffer 1, then significant volume drop.
Whats so special about loop 7 and buffer 2?
My other pedals are ok volume-wise in any of the loops and I am ok leaving the phaser in loop 7 to take care of its volume drop issue but I need a loop for the dynacomp without volume drop. (Again loop 1 with buffer 1 feed still volume drop)
Any thoughts on how to resolve and whats happening here?