Got it, that did not seem to work either, as the pedals in mind were a fuzz and a comp sustain. Really pullin' my hair on this one
The chain Goes as follows Guitar in loops 1,2,and 3 (OD,WHAMMY,TREM) Loops 5 and 6 Are Chorus and Delay 7,8 and 9 Are Comp, Bass Synth, and Fuzz.
I am just trying to find out if there is any possible way to be able to both utilize the ABY Function and Simultaneously have a Pan Pedal that would overide the PBC outputs and allow to send signal more to one amp or another if they were both on.
Is there something in the paralell/series routing that Im missing or a junction box you can think of where this would be possible?
I Cant tell if i am overthinking or if it is actually impossible to achieve this.
The orginal Setup before the Mastermind was Loops 1-3 going into a Pan Pedal that would Go to either the pedals in 5-6 (To A JC 120) or 7,8,9 To A Blues Jr. If in the middle both amps were giving something.
I apologize if any of this is redundant, just trying to really get a good signal flow so I can actually begin to build the board hah!