Hi
I have set-up different page for different effects.
Each page have a preset name assign to switches 1 to 5.
It seems that the time the preset name is shown is shorter, than it used to be, so much that i can't read the name on the display
For exemple:
I have a page for my Strymon Volante that i access by switch 8 on the PBC.
So if i am on preset 1 on the PBC, named Clean, and i click switch 8 i access the Volante Page.
Now the display shows Volante on top and Clean under to show that from the Clean preset i accessed the Volante page.
Now all the switches from 1 to 5 have a name ( Tape delay, solo etc)
Now, if i click on switch 1 to 5 i see the name on the display for the switch appears but so briefly that i almost can't read it.
So, is there a parameter to have the name of the switch appear longer?
Regards.
Pierre
I have set-up different page for different effects.
Each page have a preset name assign to switches 1 to 5.
It seems that the time the preset name is shown is shorter, than it used to be, so much that i can't read the name on the display
For exemple:
I have a page for my Strymon Volante that i access by switch 8 on the PBC.
So if i am on preset 1 on the PBC, named Clean, and i click switch 8 i access the Volante Page.
Now the display shows Volante on top and Clean under to show that from the Clean preset i accessed the Volante page.
Now all the switches from 1 to 5 have a name ( Tape delay, solo etc)
Now, if i click on switch 1 to 5 i see the name on the display for the switch appears but so briefly that i almost can't read it.
So, is there a parameter to have the name of the switch appear longer?
Regards.
Pierre