Nefarius
New Member
New user here, hi everyone!
I just got an RJM Amp Gizmo to control all switching options on a Mesa Boogie Mark V from a G-System.
My test patches 00-1 to 00-5 are set to different channels with different switching options, so they're easily identifiable. They use the default mapping 00-1 = 1, 00-2 = 2, 00-3 = 3, 00-4 = 4, 00-5 = 5.
Switching between 00-1, 00-3, and 00-5 works perfectly, just as expected.
However 00-2 and 00-4 trigger the desired change only very rarely, between once in 10 to once in 100. All the other times it's just as if no patch change signal is sent. Even numbers are quite obviously bad guys.
Any ideas?
As I'm unsure if it's a potential problem with sending or receiving I've posted the same thing over at TC.
Thanks & Greetings...
Nef
I just got an RJM Amp Gizmo to control all switching options on a Mesa Boogie Mark V from a G-System.
My test patches 00-1 to 00-5 are set to different channels with different switching options, so they're easily identifiable. They use the default mapping 00-1 = 1, 00-2 = 2, 00-3 = 3, 00-4 = 4, 00-5 = 5.
Switching between 00-1, 00-3, and 00-5 works perfectly, just as expected.
However 00-2 and 00-4 trigger the desired change only very rarely, between once in 10 to once in 100. All the other times it's just as if no patch change signal is sent. Even numbers are quite obviously bad guys.
Any ideas?
As I'm unsure if it's a potential problem with sending or receiving I've posted the same thing over at TC.
Thanks & Greetings...
Nef