Greetings Friends,
So I have three issues I would like to tackle in this discussion:
1. I am trying to create three momentary IA buttons in my GT10. I require all three of them to turn the Synth Block of my AxeFx3 'on' when pressed, and 'off' when depressed. This seemed easy enough at first! However, Switch 1 should be programmed to select Channel A, Switch 2 to Channel B, and Switch 3 to Channel C. But for some reason, I can only get the GT10 to obey only one of the two actions I have programmed in the editor for each switch (depending on the order they are in). I can't seem to get it to obey both actions in a single press. What am I doing wrong? Please see images attached for the action programming for each switch.
2. Previously I was using an expression pedal to control the 'mix' knob in the Synth Block. Can I program each of the above momentary switches to also activate the mix knob and slowly lift the mix relative to the amount of time I have my foot on the switch?
3. Is it possible to program a toggle button on the GT10 to alter variableswithin the Synth Block? For example can the 'Shift' knob in the Synth Block be controlled by a switch so that when the button is off, it could select the -24 value; and when it's on, it would select the +5 value. Is this possible at all?
Many thanks!!
SWITCH #1:
SWITCH #2
SWITCH #3
So I have three issues I would like to tackle in this discussion:
1. I am trying to create three momentary IA buttons in my GT10. I require all three of them to turn the Synth Block of my AxeFx3 'on' when pressed, and 'off' when depressed. This seemed easy enough at first! However, Switch 1 should be programmed to select Channel A, Switch 2 to Channel B, and Switch 3 to Channel C. But for some reason, I can only get the GT10 to obey only one of the two actions I have programmed in the editor for each switch (depending on the order they are in). I can't seem to get it to obey both actions in a single press. What am I doing wrong? Please see images attached for the action programming for each switch.
2. Previously I was using an expression pedal to control the 'mix' knob in the Synth Block. Can I program each of the above momentary switches to also activate the mix knob and slowly lift the mix relative to the amount of time I have my foot on the switch?
3. Is it possible to program a toggle button on the GT10 to alter variableswithin the Synth Block? For example can the 'Shift' knob in the Synth Block be controlled by a switch so that when the button is off, it could select the -24 value; and when it's on, it would select the +5 value. Is this possible at all?
Many thanks!!
SWITCH #1:
SWITCH #2
SWITCH #3