Thanks for your assistance. I have a replacement device. Can you confirm the following steps are correct for using 4cm with either 1 or 2 amps:
- PCB: Set Insert Loop Send = Stereo
- PCB: Set Insert Loop Return = Stereo
- PCB: Set Output = Stereo
- Config 1: When plugged into 1x amp - use Left...
In terms of next steps - (and really needing a working unit for professional gigging) - I have reach out to and advised the store I purchased on that I am having issues with the device. I'm hoping for a quick turn around E.g. replacement of this device with a new one, as opposed to send and...
Buttons will work only on page 1. I did also notice that the "Function" button will intermittently take several (+4) seconds to engage the next page. And yes - not being able to connect via USB to multiple computers suggests some hardware issue.
Hi - unfortunately the device will: a) no longer enter the setup menu (see attached video) (thus allowing factory reset) nor b) connect to the editor software (which has been attempted on multiple mac computers with multiple USB ports and cables. I'm essentially unable to control it as of now?
Just awaiting my TRS to TS cable to arrive. Don't know if it's related - but when I created an additional loops page (Loops2) - when scrolling via the function button - when arriving at Loop2 - another press of the Function button wouldn't take me to Switches (Page 5) - and all the device...
OK- how best to do that? I'm in Melbourne, Australia! (Alternatively is there something you could step me through remotely? I'm reasonably adept technically, to a point:)
Yes understood regarding the return being an input. Specifically the weak signal I'm referring to is the overall rig signal when that "side" of the return is used. To clarify i can successfully use either output a/b going to amp fx return and either INS send L/R going to the amp input, but can...
Hi:) I have narrowed down the (repeatable) issue after performing multiple tests. The INS loop has both SEND and RETURN set to STEREO. Both OUPUT A and B are enabled. This is to allow 4CM for a two amp rig. Each of the OUTPUTS going to amp FX loop RETURN function with a normal signal. Each of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.