Routing for my ISP G-string gate pre/post?

[Don Anderson]

I had it set up this was and tore apart my board now I don't remember the routing, thanks!

 

[rjmmusic]

Did you have it set up to be switched on and off, or was it set up to be on full time?

 

[Don Anderson]

On full time, unless that cuts off notes when playing clean?
Currently I have it routed: Decimator In to Send of amp. Dec Out to return of amp Guitar In on pedal is deceiving my wireless guitar signal and on the other side of the pedal the Decimator Out runs to guitar In on PBC

 

[rjmmusic]

I'v never used one, but as far as I can tell from the manual, it should be:

Guitar -> Guitar In
Guitar Out -> PBC Inout
Amp loop send -> Decimator In
Decimator Out -> amp loop return

 

[Don Anderson]

Which jacks do I use if I bypass the Gate pedal to go straight to Send and Return of the amps Loop?

 

[rjmmusic]

In your other post, I saw that you were planning on putting the delay and reverb in the amp's loop. If that's the case, here's how I would connect it:

Amp loop send -> In 7-10
Send 7 -> Decimator In
Decimator Out -> Return 7
Send 8 -> Delay In
Delay Out -> Return 8
Send 9 -> Reverb In
Reverb Out -> Return 9
Out A -> Amp loop return

 

[Don Anderson]

For some reason when activated Loop 7 mutes all sound -see other post with editor file attached