Search results
-
No Preset Problem
just got back from a gig and everything was working fine between my Axe 3 and GT16. Put everything back together to practice, and BAM! No presets! I followed the instructions to use the PCB Utility, and all i get is this never ending scroll of text. I let it go overnight, and its still...- Cristopher Hunt
- Thread
- Replies: 8
- Forum: GT General Discussion
-
Mastermind GT start up issues
I'm on firmware 3.4.2 with an Axe FX +. When MM first powers up, it goes from the preset i had turned it off on (around 400) and starts immediately dropping in number, till it gets to page 1. If you tap the page up slowly it does ok, but if you get in a hurry, then it slides up to the opposite...- Cristopher Hunt
- Thread
- Replies: 14
- Forum: GT General Discussion
-
Load with last used preset, bank down goes to 1
just curious if anyone has experienced the phenomena of loading up on the last used preset, the bank up works fine, but if you bank down, it goes to 1. I start in 500 or so, that's where all of my custom presets are, and when i bank up, it works fine, but if i bank down, the bank goes to 1 and i...- Cristopher Hunt
- Thread
- Replies: 1
- Forum: GT General Discussion
