Search results

  1. T

    Export List Based Preset & Corresponding Loops/PC &CC Commands

    It would very useful if there was a way where you could export the entire preset list and exactly what loops via a gizmo are being used and what PC/CC Commands are being sent to MIDI based devices; in a list-based/table (CSV,Excel) based view. This way if i decide that i need to change a preset...
  2. T

    Ability to get Axe FX III Scene Names into IA Button

    Is there a way (if not...It would be nice if there was) to dynamically load scene names from an Axe FX III preset into the buttons that controlled switching AxeFx scenes via cc commands. I know that you can load the presets and scenes names as actual presets within the GT, however this solution...
  3. T

    Gizmo Loop Turning Off - Two Buttons w/ Same Loop Enabled

    I know i am probably missing something simple here however for the life of me i cannot figure this one out. I have a few buttons on a setup page that i use to check my levels of analog pedals (all buttons are grouped, so only one pedal is on at a time) . I have a MorningGlory V4 on two of these...
  4. T

    [DONE] IA Action - Ability to turn off all buttons in group

    Having the ability to turn off all buttons in a group when triggering a separate button would be useful in my configuration. I have a few buttons belonging to groups that do not utilize the update/send on PC option.
  5. T

    IA Actions List View

    I think it would be good if we could have a way to see all of the IA actions and corresponding buttons triggering them in a list based view. This would have helped troubleshooting my configuration yesterday, instead of having to go into every button.
Back
Top