Hey all, I am curious if there is a way to globally bypass a certain loop from the PBC unit while preforming in a setlist?
For instance if a pedal or connection in a pedals loop begins to misbehave during a performance you could go to the loops page and remove it from all presets globally for...
My apologies if any of this has already been covered.
I am about to go into a tour with a guitarist next week, unfortunately we do not have any rehearsals to go through editing/ updates etc. They have a set up with the PBC 10 that is running Firmware version 4.3.
-Has there been any issue...
I have a friend trying to set up his pbc 10 and sending PC commands to A Mobius>Timeline>Big Sky
All the Device channels are selected (1,2,3)
And On each pedal Midi channels are correlating.I have read about the offset for changing each bank and preset (00A, 00B, Etc..) He seems to still be...
Running Two Amps out of PBC and even with dry signal, the JC 120 seems to be drastically attenuated, getting much lower volume than it should any clue?
Building a new pedal rig for somebody who uses a pan pedal between two amplifiers with separate effects going to each amp. They want to incorporate the PBC 10 into their rig and said that you could choose the percentage of signal going from each loop to each output to essentially replace the pan...
Working on a pedalboard for somebody that uses a pan pedal to switch between 2 seperate amps. Is it possible to program outputs per loop or even better per preset?
Hey all new to the PBC 10 and very excited!
Trying to set up function switches and was curious if it is possible to set them up as such because I cant seem to figure it out:
Func 1: Controls Amp reverb or Tremelo when pressed within that preset, Hold Func1 and it keeps it on globally through all...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.