Search results

  1. A

    Strymon Bigsky Midi

    Hello, I want to set up a button page for my bigsky. The first thing I was trying to do was make one button to scroll up… well I made the button type Device PC+ and it does scroll, but it defaults to a certain starting point in the bigsky. I want it to just scroll from where I currently am on...
  2. A

    PBC6/X Midi Cable

    Hi everyone, I guess I’m still super confused on how to get my Strymon pedals connecting to Nixie through PBC. From what I understand, I need to buy a bidirectional midi y cable. Does one end go to my first strymon In and the other end go to my last strymon pedal out? With daisy chain between...
  3. A

    PB6/X Signal Flow Question

    If the volume pedal is in a loop, I would need to lock it as always on to make sure it always is active right?
  4. A

    PB6/X Signal Flow Question

    Hello, I’m planning out my board to switch from PBC10 to PBC6x. I’m just wondering if I have this correct or not and where to put my volume pedal (I want it after the drives)? Guitar -> Compressor Compressor -> Input 1 Tuner -> input 2 POG -> loop 1 Daily Driver -> loop 2 Superbolt -> loop 3...
  5. A

    PBC-10 Loop Order

    Hello, Can you tell me if this is the correct setup for a stereo rig? No effects loops are being used. Also, the correct cables are being used for the stereo in/out for loops 7-10. Guitar -> Compressor Compressor -> PBC Loop 1 In/Out-> POG Loop 2 In/Out-> Protein Loop 3 In/Out-> Benson PreAmp...
  6. A

    editor shutting off

    This also was happening to me recently in the past few days. When I write changes, the percentage would stay at 0 and in the end crash the application. Any fixes?
Back
Top