A/B/Y mono output

[Lars Bøgh]

I have now setup my PBC only for pre-guitar-amp stomb boxes, hence only pbc loop 1 to loop5 are currently in use (loops 7-10 are not in use). I have connected both output to output-a and output-b on a "board pachbay", for the posibility to switch between 2 amps.

Now when I switch off either output a or output b on the switches page, the sound dies? - What have I done wrong?

Currently only output A is actually connected to an amp.

 

[rjmmusic]

Make sure both the "Mono Output" button and the "Mono->Stereo (out)" button are in the "in" position. If that's already the case, make sure you don't have a short in the patchbay - try using it without the patchbay and see if the situation improves.

 

[Lars Bøgh]

There were 2 issues. - Button "Mono->Stereo (out)" was not in the "in" position. - Also, the cable to "amp 2" had to be plugged in the "Schmidt-Array-connector-box". - When only plugged in at the "inner" side, some circuit inside the box, caused the problem.
Now I just plugin the cables to both amps, at the inner and outer side of the box, and everything works as expected.
Thanks for the hints, Ron.