I am using a few pedals in front of the amp and these are going into the first few loops of the effects gizmo. I am then running my loop rack effects from loops 5 and beyond.
A have a few different amps. When I run my Bogner Ecstasy 101b this works fine and sounds great. My setup is close to what is listed in the diagram below.
If I use my Friedman BE100 or either of my Marshall's, I get this delayed signal. ie I hit a note/chord and it is a noticeable delay until the sound comes out.
When I contact Friedman he said:"
A have a few different amps. When I run my Bogner Ecstasy 101b this works fine and sounds great. My setup is close to what is listed in the diagram below.
If I use my Friedman BE100 or either of my Marshall's, I get this delayed signal. ie I hit a note/chord and it is a noticeable delay until the sound comes out.
When I contact Friedman he said:"
ok first you should put the click stopper before the front of the amp.. Also you will have a ground loop the way you are running it.. After a click stopper you should have a isolation transformer into the front of the amp.