PBC/6X + MEGX MIDI routing for Nixie

[ACC1689]

Hello,

I just purchased the MEGX to run along with my PBC/6X. I understand using a midi splitter cable with the PBC/6x allows Strymon big box pedals to connect to the Nixie software. Does this change at all when the MEGX is used?

I think the following would allow nixie to work properly but want to make sure.

PBC/6X > output side of splitter cable > MEGX > Strymon Pedals > input side of splitter cable

 

[rjmmusic]

Yes, that's how it should be connected.

 

[ACC1689]

Thank you! Is this the correct wiring for the midi splitter cable?

 

[rjmmusic]

Yes, correct. The green wire in that diagram should be the bare wire in the cable.