swap function not working and Tuner fail in slave mode GT

P

peacefield

New Member
When i follow the instructions in the manual the ""swap"" function does not work.
It should blink and give you a choice which butttons you wish to swap but when i press the button nothing happens at all.
Any ideas? I run it in slave mode in combination with a KPA.
Have the latest firmware installed btw.
Another issue is the tuner, when i run the GT in slave mode all effects show there status and i can easy change CC''s and store them but the tuner doesn''t work in slave mode. Why?
Thanks in advance.
 
Re: swap function not working and Tuner fail in slave mode G

I'll look into those issues and see what I can figure out...
 
Re: swap function not working and Tuner fail in slave mode G

I have made the GT the master instead of slave and now the tuner works fine.
But i have no idea why there is no respnonse at all when i press the swap button.
No blinking no nothing.
Any ideas?
 
Re: swap function not working and Tuner fail in slave mode G

Which version of the firmware are you running?
 
Re: swap function not working and Tuner fail in slave mode G

Hi, i am using version 2.1.1 build 868
hope this helps.
 
Re: swap function not working and Tuner fail in slave mode G

Ok, which model of GT do you have?
 
Re: swap function not working and Tuner fail in slave mode G

Ok, I will make sure I check that.
 
You must log in or register to reply here.
Back
Top