Using a IA Cycle to switch between 2 different ExpPedal control

[Niko]

Hi!

I try to use one button on the LT to switch between 2 different expression pedal settings blocks. I would to use the IA cycle option.

I set up 3 settings blocks in the global menu for the expression pedal:

block 0 (Pedal OFF) with NONE device and NONE CC number
block 1 (Overdrive) with the target device and its CC number
block 2 (Bit reduction) with the target device and its CC number

I went to the relevant button page and program an IA cycle as follow:



I saw in the manual that for IA cycle, you have to switch off the former command to allow the new command to be sent.

It does not work :-/

Any advice?

Thanks a lot

 

[rjmmusic]

There's only one expression pedal on an LT - you should only use commands that control Exp Pedal #1.

 

[Niko]

Thanks! it works