Rockobeall
Member
Is it possible to route an HX Stomp to run "pre" mono effects (filter, pitch, dynamic) in Loop 1 of PCB 10 and then have stereo wet effects in the last loop of the switcher? Pre/Post style routing basically... Wonder if 4 cable method type setup with the HX Stomp send and returns would work for this?
Here is the routing I'm thinking:
Loop 1 (mono stomp effects) Switcher send to return of HX Stomp and send of Stomp to return of switcher
Loop 2345 (analog drives)
Loop 6 (stereo post stomp fx)
Send of switcher to input of stomp and left and right out of stomp to return 1 and 2 of switcher?
And I’ll need to be sure to add a Send/Return L block in the stomp to separate those paths?
Here is the routing I'm thinking:
Loop 1 (mono stomp effects) Switcher send to return of HX Stomp and send of Stomp to return of switcher
Loop 2345 (analog drives)
Loop 6 (stereo post stomp fx)
Send of switcher to input of stomp and left and right out of stomp to return 1 and 2 of switcher?
And I’ll need to be sure to add a Send/Return L block in the stomp to separate those paths?
Last edited: