Recent content by Mike Drennan

Ok I'm a dummy. That IA button right next to it was in fact a copy of the button that was also programmed to send #19. I deleted it, and it seemed to clear the conflict. Now it is sending a 127 value when I load the preset. Whew!

Here you go!

No other buttons; I’m starting from a clean slate. The button is in fact “on” when I load the preset.

Perhaps I don't fully understand the concept, but after watching the "Mastering the Mastermind" YouTube series, I thought I had a handle. Here are some screenshots of my setup: As you can see, I have a preset created with the "Metro" button set to ON, and the "Update on Preset Change" and...

Yeah, I understand that's the logical approach. Just wondering if it would be possible in the future to add that feature in just to enhance the flexibility a bit more. Perhaps a toggle for the user to decide per device if they want to lock it to a channel or allow the channel to be set when a...

Yeah, I see your point. I guess the M32 and X32 mixers are an interesting use case because of the fact that they have so many addressable parameters that they must be split over multiple MIDI channels. But I can see that even in a direct MIDI connection to the mixer that I would only need a...

Is this something that can be changed in a firmware upgrade? Don't get me wrong, the GT22 is a fantastic device. However, for the very lofty investment that comes with it, one should expect that it is capable of this feature that is found in dozens, if not hundreds of MIDI controllers to be...

I am very puzzled by the GT's handling of MIDI devices. I can't figure out how to send actions to the same device on different MIDI channels. For example, have a look at the attached screenshot. If the Midas M32 mixer receives fader CC on CH1, scene changes on CH2, and mute CC on CH3, it...

Thanks for your reply. I ended up sending the unit in for repair and it turned out to be a faulty hardware problem. The CPU board was replaced.

I tried to connect the GT 22 to an Anker powered USB hub, and then to my computer. Unfortunately after doing so, the USB port is no longer recognized by my computer (and hence, MMGT editor). I have tried plugging it directly into a USB port with no hub. Did the port get fried somehow?