It is possible to switch channels by sending individual (instant access mode) CC numbers from the MIDI switcher.
However, when I switch by preset, the instant access switch on the switcher is set to On, but the switch on the Mini Amp Gizmo is not.
I turned on/off the SW of the mini-amp gizmo with the CC number of the MIDI controller, but when the mini-amp gizmo is set to EVH5150 III mode, it does not switch even if the CC number is sent from the MIDI controller.
Do I need to make any settings?
On a Lightning type iPad, if I use the camera adapter, do I need to use a charge & sync type cable?
And I connected my iPad Air4 to Mini Effect GizmoX with the cable that included iPad Air4,But it didn't connect.
Is this due to the iPad not being the host?
When using a TypeC-TypeC cable, does the iPad (e.g. iPad Ari4, new iPad) side become the host?
I have tried several typeC-typeC cables (compatible with data transmission and reception), but some cables were not usable.
I was able to connect my iPad to the Mini Effect Gizmo X using a USB cable (TypeC-TypeC) via the Lightning camera adapter.
Thanks so much for all your help!
I have a couple of questions.
(Question 1)
Why didn't I connect to the editor with the cable that came with my iPad?
It was possible to...
And I'm sorry many times....I have an additional question.
Does this mean that the phantom power (AC9V) output from the Effect Gizmo's MIDI IN terminal is internally converted to DC when it is input to the Master Mind LT's MIDI OUT terminal?
I was worried because the main body of Master Mind LT...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.